Well I'm in the mood for building electrics at the moment and my Maple turned up a couple days ago from curlymaple.com so following the sucess of the PRS 24custom build and the faster turn around time compared to acoustic builds I'm off again with a Santanaesque double cut build, I found a set of gibson plans and tiled the image and printed out the body shape to make a template from mdf I had lying around, I then modified it slightly with my PRStemplate to get the pickup and control positioning right for the 25" 24 fret scale I'm using, up to now I'm using the same head shape as the custom but may change it to look more like the Santana headstock, so I guess its time for some pics cos I know thats what you guys like!

this is the maple I'm using for the neck stock... its 3"x 7 5/8" flat sawn kiln dried eastern red with some lovely figure, I re sawed it to get 6 28mm rough blanks out at 30" length

and this is some fijian mahogany I had lying around, it was 8" x1" so to make the body depth up I used a 20mm maple cap

body blank glued up and bandsawed out oversized by about 3mm all round

and here it is with the routing template screwed onto it using what will be the control mounting holes



and onto the contour lines, drawn freehand

maybe should have put this pic in first , routing the neck pocket and pickup cavities before carving the top



then its back to my favourite little plane to carve the top




inside of the horn I did with a round surform


then onto the gooseneck cabinet scraper


once I'm happy with the body carve its time to cut the neck angle onto the face of the guitar


so while all this carving was going on I glued up the neck blank and let it set, its an 11degree head angle which I find is steep enough for good string break angle over the nut and it really keeps things in tune when using a trem setup and locking machine heads

http://s1054.photobucket.com/albums/s48 ... _n.jpgneck layout marked onto the blank, truss rod slot goes in now, I use a double action truss rod which requires a 6mm slothttp://s1054.photobucket.com/albums/s486/howie12374/Facebook/Double%20cut%20build/?action=view¤t=539064_2985994452434_1353021873_n.jpg" onclick="window.open(this.href);return false;

I use the routers edge guide to rout this slot while the neck blank is still square, the trussrod access on the head is also routed out at this point using a 3/8"ball end bit


time to lay out the head veneer and fretboard blank just to see how its looking, the board has a 12"radius and is already slotted to the 25"scale, there's a description on how I make my boards elsewhere in my posts


and thats as far as I've gotten in the past 2 days, what with it being a bank holiday weekend for easter....apparently that means I have to spend less time in the shop according to the litle lady ! bah....humbug